04-19-2010 01:51 AM - edited 03-15-2019 10:20 PM
Hi all
Is it possible to connect POTS phones to a switch across the network using ATA,s? Or is it a case of having to connect point to point over the structured cabling using balons back to FXS port completely by passing the network?
Thanks
Simon
04-19-2010 01:57 AM
In other words, what problem are you traying to solve ?
04-19-2010 04:22 AM
I have no structured cabling / RJ45 outlets at the required remote locations to patch back to. However they have spare switch ports going back to the comms room where the POTS lines are presented
04-19-2010 06:48 AM
You can use these for any purpose. No baluns are needed. You can also find pre-made splitters.
04-20-2010 01:20 AM
So are you saying I can use ATA's for the phones and link them back to the POTS lines over the network?
Thks
Simon
04-21-2010 07:10 AM
I am still a little confused.......does my last reply make sense?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: