cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
328
Views
5
Helpful
4
Replies

CUCM 11.5 not showing VWIC3-1MFT-T1/E1 card option in MGCP Settings

We are not getting option to add VWIC3-1MFT-T1/E1 card in MGCP configuration .

 

CUCM version 11.5

on VIC and slot 0 option showing only - NM4-4WIC-MBRD

on VIC and slot 1 option showing below cards ,

NM-HD-1V

NM-HD-2V

NM-HD-2VE

EVM-HD

NM-HDv2-0PORT

NM-HDv2-1PORT-T1

NM-HDv2-1PORT-E1

NM-HDv2-2PORT-T1

NM-HDv2-2PORT-E1

 

Am using VWIC3-1MFT-T1/E1 card in 2921 router , but in CUCM am not getting this card for MGCP gateway configuration .

1 Accepted Solution

Accepted Solutions

Jaime Valencia
Hall of Fame Cisco Employee Hall of Fame Cisco Employee
Hall of Fame Cisco Employee

I'm guessing you have not clicked on save after choosing that option.

HTH

java

if this helps, please rate

View solution in original post

4 Replies 4

Select the NM4-4WIC-MBRD and then see if the VWIC card options appears underneath it.

Dear ,

 

when we select NM4-4WIC-MBRD in card sub menu is not opening .

 

R/

Praveen

Jaime Valencia
Hall of Fame Cisco Employee Hall of Fame Cisco Employee
Hall of Fame Cisco Employee

I'm guessing you have not clicked on save after choosing that option.

HTH

java

if this helps, please rate

Thank you , after saving am able to other options ,,VWIC3-1MFT-T1/E1.

 

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: