Hey all, we had to replace our router with a T1 module attached we use to go outside on calls. I've configured everything the same, calls now come in but cant go out. When attempting to call out you get a busy signal. The router has a T1 module attached with two ports, both are registered at the gateway in the call manager. Anything obvious I can look at? Call manager and router are setup same as they were before. I have Route Group/list/patterns configured. No partitions anywhere. According to the route pattern, dialing 99 and a number should go straight to the gateway that's registered, but we just get busy signals. I don't know what else to look at.
1 Accepted Solution
Accepted Solutions
