cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
371
Views
4
Helpful
2
Replies
Highlighted
Enthusiast

CUCM 8.6 on UCS 210 C M2

Hi All,

We have deployed the CUCM 8.6 in UCS 210 M2 Server.We faced the problem VM got to hung state.There is reponse when we tried to login via WEB & CLI.

We tried to restart the UCS server using Esxi console , it didn't respond.Finally we reboot the entire UCS server using CIMC & make UC service up.

Esxi - 4.1

CUCM - 8.6

UCS C210 M2

Is any one came across this kind of scneario..

Thanks in Advance.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted

Which BIOS version are you running and which CIMC version?

We ran into a similar problem just after going live with UCS C210 and later found out that there was a known issue with the bios version that the server shipped out with.

Possible causes:

http://kb.vmware.com/selfservice/microsites/search.do?language=en_US&cmd=displayKC&externalId=1030265

CSCtw68712    UCS C-series bios fix for VMware esx intel interrupt remapping issue

Suggest you use the Host Upgrade Utility and move to 1.4.3k (we have 1.4.3j http://tools.cisco.com/squish/6Eb15
deployed and I believe variant k addresses some posible issues with LEDs on the front panel)

Upgrade procedure

http://www.cisco.com/en/US/docs/unified_computing/ucs/c/sw/lomug/1.4.x/install/b_huu_1_4_3.html

HTH,

Nick

View solution in original post

2 REPLIES 2
Highlighted

Which BIOS version are you running and which CIMC version?

We ran into a similar problem just after going live with UCS C210 and later found out that there was a known issue with the bios version that the server shipped out with.

Possible causes:

http://kb.vmware.com/selfservice/microsites/search.do?language=en_US&cmd=displayKC&externalId=1030265

CSCtw68712    UCS C-series bios fix for VMware esx intel interrupt remapping issue

Suggest you use the Host Upgrade Utility and move to 1.4.3k (we have 1.4.3j http://tools.cisco.com/squish/6Eb15
deployed and I believe variant k addresses some posible issues with LEDs on the front panel)

Upgrade procedure

http://www.cisco.com/en/US/docs/unified_computing/ucs/c/sw/lomug/1.4.x/install/b_huu_1_4_3.html

HTH,

Nick

View solution in original post

Highlighted

Hi Nick,

Thanks for Indeed help....

+5 for you

Content for Community-Ad