CUCM 9.1 DIAL NUMBER

[vitali555md]

Hi.could you help me, please. I have a number +XXX (XX) XXXXXX and when I dial this number, I can't call. Answer to me please: if it is possible this setting and if it is possible, where I can find it: in CUBE or CUCM??? PLEAS!!!!!!!

[Jaime Valencia]

Inbound???
Outbound call??
Call flow??

Sent from Cisco Technical Support iPad App

[vitali555md]

outbound call

[Jaime Valencia]

If you don't provide enough details and the exact behavior you're seeing, theres no way you'll get an answer.

Sent from Cisco Technical Support iPad App

[Carlo Poggiarelli]

Hi.
Please give a look to this doc.
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/9_1_1/ccmsys/CUCM_BK_C5565591_00_cucm-system-guide-91_chapter_010000.html#CUCM_RF_UAD8BE59_00


HTH

Regards

Carlo

Sent from Cisco Technical Support iPhone App

[vitali555md]

I set on route pattern \+!# and at \+.0!# but is doesn't work.

[Carlo Poggiarelli]

Hi.
You can try
\+.!
discard digits pre dot
prefix outgoing 00

HTH
Regards
Carlo

Sent from Cisco Technical Support iPhone App

[vitali555md]

Hi,

thanks for answer, but it do not work. "your call cannot be completed as dialed please consult your directory ..."

[Carlo Poggiarelli]

Hi.

What signaling protocol have you configure to reach your voice gateway? (MGCP/H323/SIP)

Check also the partition you have configured the suggested Route Pattern.

Let me know

Regards

Carlo

Please rate all helpful posts

"The more you help the more you learn"

[vitali555md]

voice gateway SIP;

[Carlo Poggiarelli]

Hi.

Can please post a show run of your VG and a debug voice dialpeer inout during a call to an E.164 number?

Thanks

Regards

Carlo

Please rate all helpful posts

"The more you help the more you learn"

[vitali555md]

no i don't

[Carlo Poggiarelli]

In this case we can't help you.

Regards

Carlo

Please rate all helpful posts

"The more you help the more you learn"

[vitali555md]

thanks for help

[derek.andrew]

It appears you are requiring the # character at the end of the phone  number, and also sending that to the telco. (I cannot see the entire  route pattern or translation pattern in your post.)

Try sending the number without the #

D