04-24-2018 08:59 AM - edited 03-17-2019 12:41 PM
Hi Guys ,
IS that possible to add support of CP-8800-A-Kem module to CUCM 8.6 ?
04-24-2018 11:38 AM
Yes it is.
As per the data sheets its supported.
Table 3. System Requirements
Phone Firmware/Call Control Server |
Release |
Cisco IP Phone 8800 firmware |
10.2(2) and later |
Call-control compatibility |
Cisco Unified Communications Manager Version 8.5(1) and later; and Cisco Unified Survivable Remote Site Telephony (SRST) 8.0 (with Cisco IOS® Software Release 15.1(1)T) and later
|
Cheers
Rath!
***Please rate helpful posts***
04-25-2018 03:58 AM
A-KEM is different than BKEM . A-KEM = 28 buttons , BKEM =36 . On CUCM 8.6 we see only BKEM , so question is was how to add CP-8800-Audio 28 Button to CUSCm 8.6? Is any device pack for that ?
04-25-2018 01:01 PM
Hi
The only reference on the new KEMs (A & V) seems to be in 11.0.1. So my assumption, you might need to upgrade the CUCM to 11.X
"QED checkin for CP-8800-A-KEM and CP-8800-V-KEM"
I prefer you open up a PID Case with Cisco at www.cisco.com/go/pdi
HTH
Cheers
Rath!
***Please rate helpful posts***
04-26-2018 12:47 AM
Hi ,
Thanks so much . We prepare for upgrade
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide