06-03-2017 10:25 AM - edited 03-17-2019 10:29 AM
I have a topology like this-
iPphoneA->cucm->switch(sw1)->router(R1)->router(R2)->switch(sw2)->IPphoneB.
Both of my phones are registered to the Centralized CUCM.
My question is: Do I need any trunk , gateway or dial peers on any router for the call to work?
or will it work fine without any further configuration?
Solved! Go to Solution.
06-03-2017 12:26 PM
No, if both phones are registered to same CUCM there's not need of anything else.
Are both phone on <none> partition? If not, it could be related to CSS/Partition permissions.
Regards
06-03-2017 12:26 PM
No, if both phones are registered to same CUCM there's not need of anything else.
Are both phone on <none> partition? If not, it could be related to CSS/Partition permissions.
Regards
06-03-2017 06:45 PM
Thank-you for answer. It cleared my doubt.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide