01-06-2012 02:19 AM - edited 03-16-2019 08:50 AM
Hello,
Here is the scenario , I have following dial-peer
Dial-peer voice 1000 pots
Destination-pattern 9........ ( 8 dots)
Port 0/0/0:15
Dial-peer voice 1001 pots
Destination-pattern 9T
Port 0/0/0:15
When i dial 9 1111 1111 11 then call is matched to dial-peer 1000 and send out only 1111 1111 and drop the last two 11. Why this number does not match the dial-peer 1001 ? Is there any setting to be configured on the voice gateway in order to wait all the number to be matched and route it out on the dial-peer 1001 ?
Thanks
01-06-2012 02:35 AM
That is working as designed. As soon you enter 9 and any 8 digits, DP 1000 is matched because it's the only DP configured exactly to do that.
You have a case of overlap. If you want some numbers to be matched right away, and others by timeout, you can disambiguate the patterns using digit matches. If you can't do that (unlikely), you have to use a single DP, configured with Timeout.
01-06-2012 06:22 AM
Hi,
Well put by Paolo (+5)
Here is an additional link to help you
learn about dial peers
http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml
HTH
Alex
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide