Hi,
I have one cisco 3825 (IOS 12.3.11T8), with one VIC2-2BRI-NT/TE, interconnect with gsm interfaces.
In show isdn status i can see that Layer 1 and L2 are up. But when in show dial-peer voice summary i saw outbond state of dial-peer that is using that card is down and i can't make calls.
If i use no dial-peer outbond status-check pots command i can make outgoing calls, but this could bring problems when making outgoing calls if port is really down.
My config is:
interface BRI0/2/0
no ip address
isdn switch-type basic-net3
isdn overlap-receiving
isdn point-to-point-setup
isdn incoming-voice voice
isdn sending-complete
isdn static-tei 0
isdn skipsend-idverify
dial-peer voice 933 pots
destination-pattern 93.......
progress_ind setup enable 3
progress_ind alert enable 8
progress_ind progress enable 8
direct-inward-dial
port 0/2/0
forward-digits all
Any suggestions?
Best Regards,
MC