Hi everyone,
I'm having trouble trying to route calls through an IP trunk for some reason.
I've got the following two dial-peers:
!
dial-peer voice 5 pots
description Primary Outgoing Line
preference 1
destination-pattern 1T
port 0/1/1
forward-digits all
!
dial-peer voice 20 voip
description VoIP Trunk
destination-pattern 9[12]...
session target ipv4:172.30.0.10
no vad
!
The problem is that when I dial 91, the line goes out the voice port rather than the voip trunk!
As seen, there are two needs:
1) when dialing 1xxxx, it must go out the voice port
2) when dialing 91xxxx, it must go out the voip trunk.
Any suggestions as to how I can resolve this ?
Many thanks.