cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
351
Views
0
Helpful
1
Replies

dial-peer SIP Can I group them

CARLO CALABRESE
Beginner
Beginner

I need to find a usable document on Dial-peers.

I have MGCP gateways that I want to move to SIP. But I route all calls with 10 digits because I have 4 different area codes and most of the key system I have attached need 10 digits.

Going to the PSTN, I prefix the pattern with a 2 so it will only goto the PSTN and I have a huntstop command in the dial-peer.

But is there a way to group the dial-peers so that the PRI’s and analog ports only see the ones I specify and inbound sip calls only see the other dial-peers.

There seems to be a lot of documents on dial-peers, but can’t find a useful one.

1 Reply 1

paolo bevilacqua
Hall of Fame Master Hall of Fame Master
Hall of Fame Master

You can use a COR configuration to do that.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers