Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1724
Views
0
Helpful
3
Replies

direct RTP media flow on SIP phone using CME

nikolay-shopik
Level 1
Level 1

‎12-12-2007 02:59 AM - edited ‎03-15-2019 07:44 AM

Hi everyone,

I have testing setup of CME and everything works fine expect RTP media always goes through my CME router, even if telephones in same network. Is this works for SIP with CME? I know where MTP which only for SCCP phone.

Also I have kind unknown problem for me if I have access-list on my internal interface audio doesn't work on phone.

I've already done some debugging on access-list and see no problem with it, even adding ip address of phone doesn't solve problem. Logging all deny packets don't reveal any blocked RTP packets.

sh run in attachment

Labels:
Preview file
12 KB
0 Helpful
3 Replies 3

nikolay-shopik
Level 1
Level 1

‎12-12-2007 06:15 AM

ok, media flow-around - is doing trick for my case.

0 Helpful

nikolay-shopik
Level 1
Level 1
In response to nikolay-shopik

‎12-12-2007 08:28 AM

Quite strange, why I don't have media flow-around under voice service voip?

Running c2800nm-adventerprisek9-mz.124-11.XW5

0 Helpful

o.melendres
Level 1
Level 1
In response to nikolay-shopik

‎02-07-2014 07:44 AM

In my case the command is found under voice service voip. The command was added on a later software release, on the T train of 12.4 or 15

0 Helpful
Customers Also Viewed These Support Documents