I´m creating an Estimate in the CCW tool and I´m adding parts of a Cisco 2901 Gateway. However the IOS is a little different of the DSP calculator shows. In Estimates and Configuration (CCW Tool) you can see:
But in The DSP calculator you see:
Does anyone know how to match the IOS in both tools? How can I identify them and match them?
Join this featured IT Admin Control Hub session where you’ll hear about the improved Meeting diagnostics capability in Control Hub which provides IT Admins richer insights about their meetings, the participants and the quality of service. See metrics to h...
This document explains how to register a Cisco TelePresence or WebEx device to Cisco WebEx Cloud Service Using API or Local Web Interface use. This procedure is applicable for Collaboration Endpoint Software 9.8 and later. In previous versi...
SymptomsCER or other Cisco UC platform servers fail to boot with an error message immediately on startup similar to:FATAL: Could not load /lib/modules/2.6.32-642.el6.x86_64/modules.depDiagnosisYou do some searching, and think it's related to this bug - CS...
This Log Analysis tool helps you analyze the call processing and the signaling information collected by the XSLog logs from the Cisco BroadWorks system. This tool also supports a broad range of other Cisco products and technologies...
We are excited to announce we have enhanced our Webex Online Courses Program to offer a variety of courses to help customers increase their knowledge and skill-set on the features and functionalities of their Webex product.
Free – all courses