08-05-2012 10:27 PM - edited 03-16-2019 12:32 PM
Dear All,
I have 2801 router. Under voice-card 0, I can't have "dspfarm" command. Only "dsp services dspfarm" command it takes. When I tried to bring up voice channnels on T1 controller it gives me error message insufficient resources. I want to use this command to bring up the channels.
Please suggest how to do this.
I have attached the sh ver, and error message along with sh tech support as I can not paste it here.
Solved! Go to Solution.
08-06-2012 05:09 AM
You cannot have a VWIC in slot 0 of a 2801, put the T1 card in slot 1, try again and it will work.
08-06-2012 02:33 AM
You have very limited DSP resources installed in the chassis. Remove the 'dsp services dspfarm' command since that consumes DSPs and isn't required for TDM media termination, shut controller 0/0/1, and try configuring channels on 0/0/0 again.
The DSP Calculator can help you understand what is required for what you intend to do.
Please remember to rate helpful responses and identify helpful or correct answers.
08-06-2012 04:18 AM
Tried what you suggeted. Still it gives the same error message as insufficient resources.
08-06-2012 05:09 AM
You cannot have a VWIC in slot 0 of a 2801, put the T1 card in slot 1, try again and it will work.
08-08-2012 06:25 AM
U R right sir !!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide