Hi All,
I managed to establish E1 CAS connection between Cisco 2800 series router & a 3th party TDM IVR.
With the following commands,
controller E1 0/1/0
framing NO-CRC4
clock source line primary
ds0-group 1 timeslots 1 type fxo-loop-start
ds0-group 2 timeslots 2 type fxo-loop-start
And tried to do the same thing with a AS5400 XM but unfortunatelly “fxo-loop-start” is not supported in AS 5400XM
(config-controller)#ds0-group 0 timeslots 1 type ?
e&m-fgb E & M Type II FGB
e&m-fgd E & M Type II FGD
e&m-immediate-start E & M Immediate Start
fxs-ground-start FXS Ground Start
fxs-loop-start FXS Loop Start
none Null Signalling for External Call Control
p7 P7 Switch
r2-analog R2 ITU Q411
r2-digital R2 ITU Q421
r2-lsv181-digital R2 LSV 181
r2-pulse R2 ITU Supplement 7
sas-ground-start SAS Ground Start
sas-loop-start SAS Loop Start
Which one should i use instead of “ fxo-loop-start “
Thanks for your help.
