Hi,
Am i correct to configure the card in this manner in Southern Africa, for CME - please help correct where i might be wrong:
isdn switch-type primary-net5
!
card type e1 0 0
!
controller E1 0/0/0
pri-group timeslots 1-31
description **Link to SP**
!
voice-port 0/0/0:15
cptone ZA
bearer-cap Speech
!
interface Serial0/0/0:15
no ip address
encapsulation hdlc
isdn switch-type primary-net5
isdn overlap-receiving
isdn incoming-voice voice
isdn sending-complete
no cdp enable
no shut
!
!
interface GigabitEthernet0/0
description LAN Interface
ip address 10.20.30.1 255.255.255.0
ip virtual-reassembly in
duplex auto
speed auto
!
!
mgcp profile default
!
sccp local GigabitEthernet0/0
sccp ccm 10.20.30.1 identifier 1 version 7.0
sccp
!
sccp ccm group 1
bind interface GigabitEthernet0/0
associate ccm 1 priority 1
associate profile 1 register CME-CONF
!
dspfarm profile 1 conference
codec g711ulaw
codec g711alaw
codec g729ar8
codec g729abr8
codec g729r8
codec g729br8
maximum sessions 4
associate application SCCP
!
!
dial-peer voice 1 pots
description Inbound Calls Dial Peer
incoming called-number .
direct-inward-dial
port 0/0/0:15
!
!
dial-peer voice 10 pots
description Inbound Calls Dial Peer
preference 3
destination-pattern 0T
clid strip
forward-digits all
!
dial-peer voice 11 pots
description Inbound Calls Dial Peer
preference 2
destination-pattern 0[0-8][0-9].......
clid strip
forward-digits all
!
dial-peer voice 11 pots
description Inbound Calls Dial Peer
preference 1
destination-pattern 0[0-8][0-9].......#
clid strip
forward-digits all
!
!
---------------------Assuming telephony-service, routing, ephones and ephone-dn exists together with DHCP and all other needed configs------------------