i dont think there is a one size fits all for the german dial plan, you mention e164, is this dialing into your organisation, in which case I would set to E164 on your incoming GW/Cube. a lot of siip provider will already send you e164, for outbound its slightly different as people tend to not dial e164 outbound, if dialed from numberpad, so you would still need the non e164 route patterns. i would translate them to e164 outbound so you can have a single +49! for all outbound calls , route pattern,
but there are other ways to deal with it,
maybe you can eleborate a bit more on your requirements
Please remember to rate useful posts, by clicking on the stars below.
This document is intended to receive any new ideas for TAC to create new useful walkthrough videos to help set up deployments, integrations, etc.
Feel free to share any feedback about new walkthrough videos you consider useful, please share your o...
Configuring Cloud Connected PSTN (CCP) – Easy as 1-2-3!
STEP 1: PREPARE
Before you can configure your CCP in Control Hub, you must procure PSTN services from an authorized Webex Calling CCP Partn...
To participate in this event, please use the button to ask your questions
This topic is a chance to discuss more about how to read Cisco Unified Communications trace files. In this session, Cisco D...