cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Examing FXO Ports on Cisco ISR (VIC2-4FXO)

david.lumbers
Beginner
Beginner

Hi,

I can't remember so I want to ask which command is showing us FXO port's idle line voltage? How can I see the line connected or not with FXO interface from CLI.

Best regards,

David

1 ACCEPTED SOLUTION

Accepted Solutions

alxzzzzed
Beginner
Beginner
3 REPLIES 3

Payal Bhaduri
Cisco Employee
Cisco Employee

Hi,

The show voice port summary command can help you.

R1#show voice port summary
PORTCHSIG-TYPEADMINOPERIN
STATUS
OUT
STATUS
EC
========================================================
0/0/0--fxo-lsupdormidleon-hooky
0/0/1--fxo-lsupdormidleon-hooky
0/0/2--fxo-lsupdormidleon-hooky
0/0/3--fxo-lsupdormidleon-hooky
2/0/0--fxs-lsupdormon-hookidley
2/0/1--fxs-lsupdormon-hookidley
2/1/0--e&m-wnkupdormidleon-hooky
2/1/0--e&m-wnkupdormidleon-hooky

I' m sorry but there is a misunderstanding here. I want to know, how can I see the TELCO line cable (RJ11) is connected with VIC2-4FXO line card when it's inactive from Cisco ISR CLI. I suppose the command what you send is only showing line values when the line is active.

Best regards,

David.

alxzzzzed
Beginner
Beginner
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: