Expressway E GUI Access gone after changing ipv4 gateway address

[shihab.kp]

Hi,

we are having expressway dual nic setup.

in expressway e ip configuration i changed ipv4 gateway and given LAN2 Default gateway.

like the below snap

now web interface is not coming and please suggest how can i revert the configuration through cli.

#installwizard only able to set ip only

[Maren Mahoney]

It is possible you will need a static route enabling the Expressway-E to respond to LAN traffic. Take a look at:

Expressway Basic Configuration Deployment Guide - Chapter: Advanced Networking Deployments/Static Routes Towards the Internal Network 

Maren

[Roger Kallberg]

As @Maren Mahoney wrote you need to add a static route on LAN1 that routes internal traffic to the router on that network. You can add that from the console CLI in VMware.