02-07-2012 10:38 PM - edited 03-16-2019 09:27 AM
Is it possible to keep cisco fax ATA 187 on one site and pstn line (fxo or E1) on antoher site. These 2 sites are connected with GRE Tunnel. I tried its working but i need to tune it. Its rings but when we send fax...it gets disconnected.
I have registered that ATA on Callmanager....and configured one voip dialpeer to reach that line of ATA on CUCM.
Is there any other design to run fax in this scenario (where line is absent where fax ata is dere)
02-11-2012 02:09 AM
If you make a voice call, is the audio OK?
If YES, what is the codec used? What is the fax method used (fax passthrough, cisco fax relay, T.38)?
Regards.
02-11-2012 02:34 AM
Checkout following documents for configuration & Troubleshooting FOIP using ATA.
HTH
GP
Pls rate helpful posts !!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide