cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2288
Views
12
Helpful
3
Replies

Firmware phone in CME.

jcinco_555
Level 1
Level 1

f

Good morning team,

I have a qauestion, I am upgrade a phone (SPA5044G)  in CME (UC560-FXO-K9),

I  configure the next.

tft-server flash:namefimware alias nuevofirmware

telephonyy-server

load 504  nuevofirmware

ephone 20 pd

resent

end

I think the upgrade working properly, but i dont know if any comand for see the  firmware in use for the phone ?

1 Accepted Solution

Accepted Solutions

luirami2
Cisco Employee
Cisco Employee

Jorge,

You can run the command "show ephone phone-load"

That will show you the firmware version of each phone registered to CME based on Mac-address.

Please rate this post if it was helpful.

Thanks,

Luis Ramirez

View solution in original post

3 Replies 3

luirami2
Cisco Employee
Cisco Employee

Jorge,

You can run the command "show ephone phone-load"

That will show you the firmware version of each phone registered to CME based on Mac-address.

Please rate this post if it was helpful.

Thanks,

Luis Ramirez

Luis,

Thanks for you help,  excelent reply.

I also use show cdp entry * version in my switch,  but it only use if the pone use cdp rigth, show ephone phone-load

can i use with other phone ?

regards

Jorge Cinco

Just like you said, show dsp neigbors detail will show you good ingormation about the phone, but the swith and the phone need to support CDP protocol.

The show ephone phone-load will show you the firmware for every registered phone.

Please rate this post if it was helpful.

Thanks,

Luis Ramirez

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: