cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1059
Views
0
Helpful
3
Replies

Firmware

First off thank you for taking the time to extend me any assistance. I'm rather new at this. My question is, I am receiving this error when trying to get firmware into my configuration so I my Cisco IP 88** can update.

 

example: 

TPTP-server flash:/CME-12.0/phone/XXXX/7975/cnu75.9-4-2ES26.sbn alias cnu75.9-4-2ES26.sbn

 

Error received 

Demo(config)#tftp-server flash:sip88xx.14-0-1-0101-145
Warning: bootflash:sip88xx.14-0-1-0101-145 does not exist.  Command retained.  
 
I am basically trying to move a my completed config over to another router. But once again I am not sure how to go about doing that. So if that would be easier I would like to hear on how to do that. But still need to learn the long route.. Thank You Again for taking you time out to help me...Cg
2 Accepted Solutions

Accepted Solutions

Are you trying to configure the TFTP path for the phones to take the new  firmware ?

 

 



Response Signature


View solution in original post

Have you verified that the file that your pointing to actually exists on the flash of the router?



Response Signature


View solution in original post

3 Replies 3

Are you trying to configure the TFTP path for the phones to take the new  firmware ?

 

 



Response Signature


Thank You for your help on this your information was helpful

 

Have you verified that the file that your pointing to actually exists on the flash of the router?



Response Signature