full-consult transfer does work as full-consult on CME with VG-224 as

[Sergey Balyura]

Hello, everybody!

I have a very annoying situation.

I have CME with VG-224 connected ovet SCCP. and about 10 analog phones.

in the "telephony-service" section I have "transfer-system full-consult" statement.

but it does not work as full-consult!

this is the picture I have:

1. two abonents - A and B - connected.

2. Abonent B push the hookflash button to transfer the call towards the abonent C. Abonent A has the silence.

3. Abonent B hears the silence and dial the number of abonent C.

4. Abonent B has the silence. Abonent C has the ring on the his phone.

5. Abonent C picks up the phone. two abonents - A and C - have a conversation.

6. Abonent B still has just the silence in the phone.

7. to make other call abonent B has to hang off the phone and hang on again.

so there is no full-transfer at all.

I don't know where to dig!

please, help me!

[paolo bevilacqua]

Post config.

Note, there is no word "abonent" in English.

[Sergey Balyura]

hello!

thanx, but I think my text is clear even with the unknown word "abonent"

solved. my fault. the reason was just in missing of "dual-line" option.

every ephone-dn was configured with one line.

thanx again.