FXO/FXS port status connected or not

[nso20]

Hi all,

I registered my MGCP gateway ISR 2911 and its interfaces E1/FXO/FXS on CUCM BE6k 10.5, however I could not know which of these FXO/FXS ports are connected physically or not. On CUCM all are shown as registered and on ISR their status as below. How can I know they are physically connected ?

show voice port summary

0/1/0           --  fxo-ls      up    dorm idle     on-hook  y
0/1/1           --  fxo-ls      up    dorm idle     on-hook  y
0/2/0           --  fxo-ls      up    dorm idle     on-hook  y
0/2/1           --  fxo-ls      up    dorm idle     on-hook  y
0/2/2           --  fxo-ls      up    dorm idle     on-hook  y
0/2/3           --  fxo-ls      up    dorm idle     on-hook  y
1/0/0           --  fxs-ls      up    dorm on-hook  idle     y
1/0/1           --  fxs-ls      up    dorm on-hook  idle     y
1/0/2           --  fxs-ls      up    dorm on-hook  idle     y
1/0/3           --  fxs-ls      up    dorm on-hook  idle     y
1/0/4           --  fxs-ls      up    dorm on-hook  idle     y
1/0/5           --  fxs-ls      up    dorm on-hook  idle     y
1/0/6           --  fxs-ls      up    dorm on-hook  idle     y
1/0/7           --  fxs-ls      up    dorm on-hook  idle     y

[Nadeem Ahmed · Accepted solution]

Use "show voice cable-status all" command to see the cable status however you need to configure(cable-detect) the same under voice-port

Refer to following link to get more info on cable-detect-poll-timer and information on show command to analyze cable detect

http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/vcr1/vcr1-cr-book/vcr-c1.html#wp1481671078

Refer to following link to get moe info on show commands for cable status

http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/voice/vcr4/vcr4-cr-book/vcr-s9.html#wp3323260709

[nso20]

Thanks a lot Nadeem