03-04-2015 01:50 AM - edited 03-17-2019 02:12 AM
Hi Team,
I have cisco 2911 voice supported router
I have 2 FXO ports on which I have connected 2 lines and I am planning to make a PSTN call using my Cisco IP phone
I tried with MGCP but due to caller ID issue, I am now planning to go for H.323.
Can any one send me a link or guide to configure the same using H.323?
I have cisco IP phone 2
CUCM version 9.1.2
Voice gateway 2911
Connection PLAR number 450001 and 450002
Also with debug commands with respect to only FXO troubleshooting incase of call failure etc. like debugccapi inout etc.
Regards,
Steffy
03-04-2015 03:36 AM
Please help !!!
Using this IP phone I wanted to make a PSTN call and for incoming call my PLAR will be 450001
and voice port is 0/0/1 to which the FXO line is connected.
Please help me with dial-peer config also to make outbound and inbound calls
03-04-2015 04:14 AM
There's plenty of information if you care to search CSC or google
https://supportforums.cisco.com/discussion/11674361/fxo-and-need-plar-config
http://www.gossamer-threads.com/lists/cisco/nsp/87077
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide