01-30-2008 04:00 PM - edited 03-15-2019 08:32 AM
Hi,
I am working with 8 analogues lines for a UCME / H323 gateway (Cisco 2811). I know the Telco can configure the 8 lines in a rotary upon request but in the event that they are not. Are there any configurations on the voice ports for especially for outbound calls.
Kind regards,
Richard.
01-31-2008 03:01 AM
Use the preference command under the POTS dial peers to set up a order of outbound hunting. Preference 0 is the default, so it does not show in the config, so leave it off your first dial peer, then add preference 1-9 for the other dial peers.
01-31-2008 03:13 AM
voice-port x/y/z
trunk-group pots
dial-peer voice 9 pots
destination-pattern 9T
trunkgroup pots
This allows you to configure a single DP to control all lines. You can also set other properties under "trunk group pots"
Hope this helps, please rate post if it does!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide