H.323 gateway and gatekeeper on a single router?

[xiaoliangyue]

The 2911 router is already configured as an H.323 gateway to CUCM8.5.

I'm planning to configure this same router as H.323 gatekeeper, both CUCM and the H.323 gateway (same box) will then register to it. I have an H.323 device that has to register to a gatekeeper. The IOS version of router is 15.0.

Any input is appreciated!

Jonathan

[nitsinha]

The below two docs should help you in configuration

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/cisco_ios_h323_configuration_guide/old_archives_h323/4gwconf.html#wp1036043

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/cisco_ios_h323_configuration_guide/old_archives_h323/5gkconf.html

Check this doc for gatekeeper concepts

http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a00800c5e0d.shtml

Hope that helps

Regards

Nitesh

PS:Pl rate helpful posts

[xiaoliangyue]

thanks for the info, Nitesh. i've worked on every piece of them, cucm, h323 gw, h323 gk, just not sure if h323 gw & gk can cowork on a single router. i  heard that h323 gk should use a router alone a few years ago, however that restriction might be related to old ios version.

[nitsinha]

That was a problem in CUCM version 4.x. Don't think  you should face a problem in the later versions.

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCed68448

Hope that helps

Regards

Nitesh

PS:Please rate if this helps