11-09-2010 08:27 AM - edited 03-16-2019 01:49 AM
Hi,
I'm having problems with a voicemail.
Scenario:
CME configure with a Unity Express for voice mail. When i call from the PSTN the Auto-Attendat picks up the call,
the call is transfer to an extension. I let the extension ring until forward the call to the voicemail.
Once i hear the message "leave your message for xxxx", i leave the message but the mailbox doesn't receive any message. The phone doesn't turn on
the light indicating a new message has arrived. I have configure MWI on the CME. I also have configure the voice mail in the unity:
CME:
===
ephone-dn 61
number A61.... no-reg primary
description FOR MWI-ON
mwi on
ephone-dn 62
number A62.... no-reg primary
description FOR MWI-OFF
mwi off
dial-peer voice 5000 voip
description *** FOR VOICE MAIL ****
destination-pattern 5000
session protocol sipv2
session target ipv4:10.234.144.254
dtmf-relay sip-notify rtp-nte
codec g711ulaw
no vad
UNITY VOICEMAIL CONFIG:
====================
voicemail mailbox owner "Rigsanchez" size 5400
description "Rigoberto Sanchez mailbox"
end mailbox
Other thing i noticed is that when i'm leaving the message and press #, for more option, the system tells me that the message is too short.
Can somebody help me?
Thansk for your response
Solved! Go to Solution.
11-09-2010 01:05 PM
Can u try adding this while trying g729r8 (default) codec ?
sip-ua
g729-annexb override <--- add this (hidden so pl. just type)
11-09-2010 05:26 PM
Hi Dilip,
I tried the last command you told me and now is working fine.
Thanks a lot for your help.
11-09-2010 06:45 PM
Hi there,
Great! I am glad that it worked out....
That command causes IOS to interop with systems
not compliant with rfc 3555.
Pl. mark this thread as answered and
rate as appropriate..
Thx,
DK
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide