01-27-2012 08:56 PM - edited 03-16-2019 09:15 AM
I had 8.5.1.10000-26 of CUCM installed and upgraded to an Unrestricted version of 8.5.1.13900-5. I later researched that I do not want an Unrestricted version and should have the Restricted instead. I switched versions back to 10000-26 and it warned me I needed to do a 'utils dbreplication reset all' after the Publisher came back up. Note: The Subscriber was never switched over to 13900-5 and remains on the Inactive partition. We only have the two servers, 1 Pub and 1 Sub.
So how do I tell if this dbreplication reset has completed successfully? I've issued the following commands and I will paste the output...
admin:utils dbreplication status
-------------------- utils dbreplication status --------------------
Replication status check is now running in background.
Use command 'utils dbreplication runtimestate' to check its progress
The final output will be in file cm/trace/dbl/sdi/ReplicationStatus.2012_01_27_22_50_57.out
Please use "file view activelog cm/trace/dbl/sdi/ReplicationStatus.2012_01_27_22_50_57.out " command to see the output
admin:
and
admin:utils dbreplication runtimestate
DB and Replication Services: ALL RUNNING
Cluster Replication State: Replication status command started at: 2012-01-27-22-50
Replication status command COMPLETED 530 tables checked out of 530
No Errors or Mismatches found.
Use 'file view activelog cm/trace/dbl/sdi/ReplicationStatus.2012_01_27_22_50_57.out' to see the details
DB Version: ccm8_5_1_10000_26
Number of replicated tables: 530
Cluster Detailed View from PUB (2 Servers):
PING REPLICATION REPL. DBver& REPL. REPLICATION SETUP
SERVER-NAME IP ADDRESS (msec) RPC? STATUS QUEUE TABLES LOOP? (RTMT) & details
----------- ------------ ------ ---- ----------- ----- ------- ----- -----------------
CCMPUB1 10.14.1.1 0.052 Yes Connected 0 match Yes (2) PUB Setup Completed
ccmsub1 10.14.1.2 0.245 Yes Connected 0 match Yes (2) Setup Completed
admin:
Do I have to dig through the output file to determine success, or can anyone tell me from the command outputs I've pasted above if it was a success? Once I determine it's successful, I will try and upgrade to the Restricted version of 13900-5.
Thank you.
Rory Schmitz
Solved! Go to Solution.
01-27-2012 10:34 PM
Hi Rory,
The below doc would be helpful for you
https://supportforums.cisco.com/docs/DOC-13672
Regards,
Senthil
01-27-2012 10:34 PM
Hi Rory,
The below doc would be helpful for you
https://supportforums.cisco.com/docs/DOC-13672
Regards,
Senthil
01-28-2012 08:16 AM
Yes, that is a very well put together document. Thank you very much for posting it. I was able to determine that everything is OK and can continue on with my next upgrade.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: