Re: how to allow call from Jabber without needs to add 9
If your CUCM cluster only services a single national fixed-length numbering plan, such as the NANP, you can create Application Dial Rules. These are processed client-side before the SIP INVITE is sent to CUCM.
Because those rules are cluster-wide you usually cannot use them for clusters servicing multiple countries. In that scenario your only option is a separate CSS/Partitions/Route Patterns that do not require the off-bet access prefix. Be aware that Jabber is not exempt from the T.302 inter-digit time-out of CCM DigitAnalysis.
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...