How to configure CME on 4321 ISR router

[@Syed]

Hi All,

I have a brand new cisco 4321 & 4351 ISR router.

May I have a document for CME configuration on 4321&4351, please.

[Abhay Singh Reyal]

Find the below links helpful

https://www.cisco.com/c/en/us/support/docs/unified-communications/unified-communications-manager-express/211270-Basic-Configuration-Guide-for-CUCME-CME.html
http://www.ciscopress.com/articles/article.asp?p=1182471&seqNum=2

Note :- In order to configure the PRI on ISRG4, kindly be advised to move the PVDM from Mother Board to the Network Interface Module [In case there it is not there on NIM]. Most of the times you would get an error while configuring the PRI and then you need to take the step.
You can verify the settings by running command show inventory
HTH
Regards
Abhay

Kindly rate all helpful posts !!!

[@Syed]

Hi Abhay,

Thank you very much for the document, but it is not very clear. It would helpful if you could share a clear one, please.

[Jaime Valencia]

Have you already reviewed the CME configuration guide??

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/admin/configuration/manual/cmeadm.html

[@Syed]

Hi Abhay/Jaime,

How do I make out whether PVDM4 is on motherboard or NIM from the attached bill of quantity. I know that we can find by show inventory. Is there a way to make sure without powering the router on??

If it is on motherboard then how do I change it to NIM??

Thank you in advance

Syed

[Abhay Singh Reyal · Accepted solution]

It should something like below if the DSP is on NIM when you would run the command show inventory
NAME: "subslot 0/1 db module 0", DESCR: "PVDM4-128 Voice DSP Module"
PID: PVDM4-128 , VID: V01, SN: FOC17176BLL
It is like a card that you need to take out and put it in.
HTH
Regards
Abhay