Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All, I am running callmanager version 8.5; I have registered a brand new cisco 8865 sip phone to this CallManager. Calling is working fine but directory service isn't. It gives a blank screen when the directory button is pressed on the phone. T...
Hello All,Hope you are all doing well!I am looking for SRST solution, I have about 2500 phones and 2 CUCM nodes at branch officeand it is a critical site.I see a risk in the current setup, as the voice gateways are residing at HQ datacenter, so if th...
Hello All,Greetings!As part of best practice I am planning to upgrade sip voice gateway IOS , need your advise whether I the current IOS version is still supported or upgrade is recommended in this case. Note: There are no problems with the current v...
Hi All,I'm wondering if anyone still has this cop file backup. I've a customer still running 8.5.x cucm and the pub has been crashed, rebuilding it. Any help would be greatly appreciated. Thank you
Requirement: • Need to integrate UCCX 11.5 with a third-party CRM application using APIs• UCCX should be able to receive calls when initiated from CRM via ‘Push to Talk’ button• Inbound calls through UCCX to CRM application should see calling party n...
Hello Nithin, Thank you for the reply. I have upgraded to the below firmware as it supports from 8.5.1 https://software.cisco.com/download/home/286286015/type/282074288/release/11.7(1)?catid=280789323 My Current active version:Active Master Version: ...