How to configure PLAR for Thirdparty SIP device in CUCM11.5

[amanullahkadiri]

As per Cisco PLAR can be configure for sccp and sip phones but when i m trying to do on third party sip device sip dial rules option is not available.

[Adarsh Chauhan]

Hi,

You cannot configure PLAR on Third party SIP phones.

Please rate and mark correct if helpful

Regards,

Adarsh Chauhan

[amanullahkadiri]

Any other way to achieve this

[Adarsh Chauhan]

I am not aware of any method on CUCM that would make it work.

You might have to compromise with dialing a number which you can assign on a translation (isolate the pattern by partition) pattern and put the desired destination on called party mask.

I was going through an article where some third party settings itself had PLAR option, you can look for that.

Please rate and mark correct if helpful

Regards,

Adarsh Chauhan

[UMARSIDDIQUI]

Please share that article

---

@Adarsh Chauhan wrote:

I am not aware of any method on CUCM that would make it work.

You might have to compromise with dialing a number which you can assign on a translation (isolate the pattern by partition) pattern and put the desired destination on called party mask.

I was going through an article where some third party settings itself had PLAR option, you can look for that.

Please rate and mark correct if helpful

Regards,

Adarsh Chauhan

---