How to enable the comand debug isdn q931?

[wflores]

Hello

I have a gateway Cisco 2851.

I enable the commands via telnet and console:

router# debug isdn q931

router# terminal monitor

But eventhough there are incoming and outgoing calls from PSTN E1 ISDN PRI.

I DO NOT SEE ANY DEBUG.

Should I enable other commands in order to see these debug????

Regards

Walter

[paolo bevilacqua]

you may have logging debug set to buffer that is, no debug out to console. Check with show logging.

Hope it helps, please rate all useful posts!