07-12-2016 11:30 PM - edited 03-17-2019 07:31 AM
Hi ALL,
Recently we want to setup new branch office, we need to configure CUCM in order to use prefix call to branch <-> HQ. Due to insufficient of CUCM license, we can’t make any configuration on CUCM. Any alternative way to allow do configuration first or obtain trial license before getting the additional license?
Refer attached.
Kindly advise.
Thank you
Regards
Kevin
Solved! Go to Solution.
07-12-2016 11:40 PM
Open a case with GLO - you can just email licensing@cisco.com and obtain temporary license till you work out and buy new licenses.
You need to upload licenses and bring the system back in compliance to proceed.
-Terry
Please rate all helpful posts
07-12-2016 11:40 PM
Open a case with GLO - you can just email licensing@cisco.com and obtain temporary license till you work out and buy new licenses.
You need to upload licenses and bring the system back in compliance to proceed.
-Terry
Please rate all helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide