06-03-2013 08:13 AM - edited 03-16-2019 05:40 PM
Hello All,
I was wondering if its possible to show if there is just voice traffic on an Voice Port.
Following situation. Cisco Switch (WS-C3560-48PS) with Voice ports configured. Cisco 7961 Phones connected.
Is there any kind of command I can use on the switch to check wether a User is just calling with the Phone ?
Any help is appreciated.
06-03-2013 08:25 AM
Hi,
If you're running QoS on the 3560 (marking packet as a Layer 3 device) you can use show policy-map interface X to see if voice packet are received but there's not way to know how many call are received.
Please remember to rate useful posts clicking on the stars below.
Favor calificar todos las respuestas útiles dando click en las estrellas de mas abajo.
___________________________________________
LinkedIn Profile: do.linkedin.com/in/leosalcie
06-03-2013 08:27 AM
Hi,
a switch, as a L2 device has no idea about the notion of "calls". It simply takes and forwards frames.
G.
06-03-2013 08:31 AM
@Gergely, Cisco 3560 are Layer 3 switch, that's why I said "marking packet as a Layer 3 device".
Please remember to rate useful posts clicking on the stars below.
Favor calificar todos las respuestas útiles dando click en las estrellas de mas abajo.
___________________________________________
LinkedIn Profile: do.linkedin.com/in/leosalcie
06-03-2013 08:55 AM
@leosalcie, alright. Is it relevant to the OP.
G.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide