cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
297
Views
0
Helpful
1
Replies

Jabber client without Jabber-config.xml

Yan Tian
Beginner
Beginner

Hello team,

Some configurations (enable/disable features) for Jabber client, can not be done through either CUPS or CUCM GUI, that is why we need jabber-config.xml.

But if I simply deploy a Jabber client without Jabber-config.xml, how can I tell the features/functions, which are supposed to be enabled/disabled only through jabber-config.xml, are actually enabled or disabled by default?

1 Accepted Solution

Accepted Solutions

Jaime Valencia
Hall of Fame Cisco Employee Hall of Fame Cisco Employee
Hall of Fame Cisco Employee

Because the same documentation that tells you what each parameter does, also says what is the default value for it. If there's no .xml, or the parameter is not in the .xml you're using, it'll use the default value the documentation has.

HTH

java

if this helps, please rate

View solution in original post

1 Reply 1

Jaime Valencia
Hall of Fame Cisco Employee Hall of Fame Cisco Employee
Hall of Fame Cisco Employee

Because the same documentation that tells you what each parameter does, also says what is the default value for it. If there's no .xml, or the parameter is not in the .xml you're using, it'll use the default value the documentation has.

HTH

java

if this helps, please rate
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: