MGCP Configuration

[khanfawaz]

Hi,

I was configuring MGCP. Was adding new e1 PRIs. Added 4 PRIs successfully. But when adding 5th and 6th PRIs I am getting one error message. Is this highlighted error due to insufficient dsp rsource?

iec-v-gw-01(config-controller)#controller e1 0/2/0

iec-v-gw-01(config-controller)#pri-group timeslots 1-31 service mgcp

%Please configure network-clock-participate wic 2 first

%Insufficient resources to create pri-group - it has been removed

iec-v-gw-01(config-controller)#framing CRC4

iec-v-gw-01(config-controller)#linecode hdb3

iec-v-gw-01(config-controller)#clock source line

Regards,

Fawaz

[Chris Deren]

Fawaz,

2 things:

First ensure you define the wic with network-clock participate, i.e.

network-clock-participate wic 2

then, ensure you have sufficient DSPs, you can post your current conifig along with "sh inventory" for validation, and use the dsp calulator:

http://www.cisco.com/cgi-bin/Support/DSP/dsp-calc.pl

HTH,pleae rate all useful posts!

Chris

[khanfawaz]

Thanks chris. It worked.