08-16-2010 05:37 PM - edited 03-16-2019 12:17 AM
Hi
I have an MGCP gateway (1861) with SRST configured for WAN failure. There is BRI line connected to it and has a number 3709 3416. The extension numbers in the building are 8XXX (around 13 telephones).
in MGCP mode I have a translation pattern to translate the incmoning calls to 8XXX extensions and all works fine. during WAN failure (simulated) 1861 goes in SRST mode and 8 phones register to it randomly. during this, the incoming calls dont work. outgoing are fine. I have dial peer configured and translation rule for incoming also,
Can anyone help with the troubleshooting?
Here is SRST and dial peer confing
voice translation-rule 1
rule 1 /37093416/ /8904/
!
!
voice translation-profile SRST
translate called 1
!
!
voice-card 0
!
!
application
global
service alternate default
!
dial-peer voice 1 pots
translation-profile incoming SRST
destination-pattern 0T
incoming called-number .
port 0/1/0
call-manager-fallback
secondary-dialtone 0
max-conferences 8 gain -6
transfer-system full-consult
ip source-address 192.168.0.218 port 2000
max-ephones 8
max-dn 14 dual-line
translation-profile incoming SRST
time-format 24
!
Any help is appreciated
Thanks and Regards
Shruti
Solved! Go to Solution.
08-16-2010 08:53 PM
try to modify your pots dialpeer as follows
dialpeer voice 22 pots
incoming called-number .
translation-profile incoming SRST
direct-inward-dial
and remove the profile from the call-manager-fallback. Test it out.
if this helpful, plz rate the post.
cheers
08-16-2010 06:00 PM
Maybe you should take good cara of the Status of Callmanager MGCP gatway Cause MGCP will turn to Callmanager For Routing Calls.
And you can
show call-manager-fallback
confi ter
no mgcp
mgcp
to see if can be OK
You should lookup on MGCP troubleshoot fr cisco.com
08-16-2010 07:00 PM
Hi
Thanks for the quick reply. but the problem is in SRST mode not in MGCP.
what do you think?
thanks
08-16-2010 08:53 PM
try to modify your pots dialpeer as follows
dialpeer voice 22 pots
incoming called-number .
translation-profile incoming SRST
direct-inward-dial
and remove the profile from the call-manager-fallback. Test it out.
if this helpful, plz rate the post.
cheers
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide