mgcp overlap receiving -> no digit in call setup

[Sascha Monteiro]

Hi,

integrating a "dealer" system IPC MX via QSIG-E1 over MGCP into CCM4.1(3)

when they seize a line, it sets up a call without digits...but when they wait too long (about 1 sec) they get unallocated/unassigned number.

This is NOT the T302 timer, but how can we increase the time between call setup and first digit?

[smalkeric]

try adding "isdn overlap-receiving" command under interface Serial. Also refer this bug for more information : CSCed17244

[optionstechnology]

Hi i'm seeing the exact same issue, did you manage to resolve your problem ?

how did you fix it ?