Missing ILS CLI commands in CUCM 10.x and later

[Ankur Srivastava]

Hi Guys,

Does anyone know why were the ILS CLI commands removed from version 10.x and later:

These commands were very useful to test ILS errors but are no longer present.

eg: utils ils findroutestring

      utils ils lookup

Also , does anyone know any alternative way to troubleshoot ILS issues?

Thanks,

Ankur

[Deepak Rawat]

Hi Ankur,

You can go through the Intercluster Lookup Service section of the below document in order to get the T/S approach required for ILS issues. Starting version 10.x onwards, we only have "utils ils showpeerinfo" command available

http://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/10_0_1/ccmfeat/CUCM_BK_F3AC1C0F_00_cucm-features-services-guide-100/CUCM_BK_F3AC1C0F_00_cucm-features-services-guide-100_chapter_0100010.html#CUCM_RF_TCF4EFD7_00

Regards

Deepak

[Ankur Srivastava]

Hi Deepak,

So that means we can no longer track and search what URI are being advertised by what node? or is there another way to track this?

Thanks,

Ankur

[Deepak Rawat]

Call Manager traces.

Regards

Deepak

[Jeff Levensailor]

in 10.x you can run a route plan report, and it will show "learned" ils numbers, uris and patterns.

[Ankur Srivastava]

So this is for anyone who stumbles upon this thread.

You can check for duplicate URI using Cisco Unified Reporting.

Just go to System Report > "Unified CM Directory URI and GDPR duplicates.

There you will find the duplicate URIs and which node is advertising them.

-Ankur