01-24-2019 04:31 AM - edited 03-17-2019 02:00 PM
Hi,
I have configured Auto Attend in CUCM 7.0 with voice gateway cisco 2911 router with fxo ports and connected with analog pot line. and configure the landing number as auto attend DN (which is 4100). but the greeting is starting after 2 rings on line even though i have enabled inbound fast start on my gateway. how can start greeting directly with out the ringing .
Thanks in advance
Solved! Go to Solution.
01-29-2019 06:54 AM
01-24-2019 04:46 AM
Not using analog FXO would be the best approach. If you’re stuck on that, then try disabling disabling Caller-ID on the voice-port. The FSK data is sent between the first and second ring so IOS waits until the second ring to receive that.
01-29-2019 02:41 AM
Hi jon
Thank you very much for your support
i disabled the caller id . now two ring reduced to one
is there any way to avoid the first ring on this analog line
thanks
01-29-2019 06:54 AM
01-30-2019 08:51 AM
Thank you very much 👍
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide