Hi
Some help required please. I need to set up an analogue phone on a 4321, with 2 port FXS NIM installed. Its all set up (config below) but there's no dial tone, and the cable status on the voice port is 'not connected'. I've turned the rj11 cable back on its other voice port and it comes up.
[edit] the phones I am using are basic battery powered British Telecom phones. Nothing fancy
voice-port 3
cptone GB
timeouts call-disconnect 1
connection plar 10901
description *** local 10801 PLAR TO 10901 PORT 3 ***
dial-peer voice 10801 pots
description *** 10801 LOCAL PHONE FXS 3 ***
destination-pattern 10801
port 3
dial-peer voice 10901 voip
description *** 10901
destination-pattern 10901
session protocol sipv2
session target ipv4:172.16.1.9
voice-class sip bind control source-interface Loopback1
voice-class sip bind media source-interface Loopback1
codec g711alaw
ip qos dscp cs3 signalling
