cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
210
Views
0
Helpful
1
Replies

Not able to register Sip 7821 phones on CME version 10.5

Maxim5835
Level 1
Level 1

I have 7821 sip phones and i m trying to register them on the cme 10.5.

I have uploaded the load to flash1: cause that was the only one it would agree to, however on the register global config the tftp-path flash: command is only accepting flash: 

(config-register-global)#tftp-path flash1:
Aborted: invalid tftp path

when I run the flash command this is what im getting 

#sh flash:
%Error show flash0: (No such device)

How do I resolve this to allow me register the SIP phones.

 

1 Accepted Solution

Accepted Solutions

Maxim5835
Level 1
Level 1

Managed to get a solution for this.

I moved the flash memory from slot cf1 to cf0 on the router. allowing me to invoke the flash0/flash: where the tftp files were located.

I have attached the before and after screenshots after I switched the flash location.

View solution in original post

1 Reply 1

Maxim5835
Level 1
Level 1

Managed to get a solution for this.

I moved the flash memory from slot cf1 to cf0 on the router. allowing me to invoke the flash0/flash: where the tftp files were located.

I have attached the before and after screenshots after I switched the flash location.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: