01-03-2019 12:58 AM - edited 03-17-2019 01:54 PM
phone 7975 SCCP75.9-4-2SR1-1S
two expansion 7916 module B016-1-0-4-2
callmanager 11.0.1.20000-2
I configured the phone using SCCP, once the configuration was finalised I connected the phone - 1 x 7916 expansion modules - and its working fine , but when we connect 2 X 916 expansion , the status that the 2 expansion keep resetting , could it be simply power supply related. The two expansion modules are connected to an external power supply.
please advice
01-03-2019 04:39 AM - edited 01-03-2019 04:42 AM
Hi MK,
Please follow these steps:
In order to get those 7962 phones with 2 7915 modules and 54 buttons lines please follow the steps below:
1.Navigate to Device -- > Device Settings -- > Phone button template.
2.Select standard 7962 template.
3.Copy this template and rename it to create a template with 54 buttons.
Cisco Unified IP Phone Expansion Module 7916
01-03-2019 06:00 AM
Dear ,
same issue , still resitting every few minutes
01-03-2019 08:46 AM
Have you tried connecting only the one is resetting?
Does it work?
01-03-2019 08:55 AM
With one module it's working fine
01-03-2019 11:17 AM
Are you plugging the power cube to the right sidecar?
01-04-2019 01:28 AM
yes , may upgrading firmware for the phone will help?
we have phone 7975 SCCP75.9-4-2SR1-1S?
01-04-2019 04:53 AM
Just in case, follow these steps for connecting both Expansion Modules:
1) Plug one end of the second interface cable into the AUX jack with the “out” icon underneath on the first Expansion Module (the one closest to the phone).
2. Plug the other end of the second interface cable into the AUX jack with the “in” icon underneath on the second Expansion Module (the one next to the first Expansion Module).
If that doesn't work, let's try making a factory reset to phone.
Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide