Hello, we need to solve variability on our cvp   CVE ID: CVE-2015-0225 THREAT: Java JMX interface is accessible via following username/password pairs: admin/password admin/admin admin/activemq monitorRole/QED controlRole/R%26D controlrole/password monitorrole/password cassandra/cassandrapassword monitorRole/tomcat controlRole/tomcat monitorRole/mrpasswd controlRole/crpasswd role1/role1passwd role2/role2passwd role3/role3passwd admin/thisIsSupposedToBeAStrongPassword! QID Detection Logic (Authenticated): This QID tries to log into JMX RMI server using above credentials. Note:if remote JMX RMI sever accessible without authentication. all of above credentials will post. IMPACT: Successful exploitation allows attacker to execute arbitrary Java code. SOLUTION: Change the common password.   which password? ... View more

uccx 11 some agents randomly stuck in reserved state  Troubleshooting: ================ Unassociated then associate the phones from UCCX user We checked the port synch from UCCX  We noticed  that all phones have the same number and partition for (Auto registration number) , but the agent using the device profile , does this senario may cause the issue? any idea for reserved troubleshooting? ... View more

Hi all, cuic 11.6 , ucce 11.5 Is there any report that shows the list of calling number? ... View more

Is there any limitation for cisco 7821/41 with 3350? power ?  ... View more

Hi Finesse 11.5 , is there anyway to make the password lock after agent try to put wrong password more than 3 times on the finesse client interface?   ... View more

cucm 11.0 , is there anyway just  to change the  expansion module language and keep the phone English? ... View more

phone 7975 SCCP75.9-4-2SR1-1S two expansion 7916 module B016-1-0-4-2 callmanager 11.0.1.20000-2 I configured the phone using SCCP, once the configuration was finalised I connected the phone - 1 x 7916 expansion modules - and its working fine , but when we connect 2 X 916 expansion , the status that the 2 expansion keep resetting , could it be simply power supply related. The two expansion modules are connected to an external power supply. please advice ... View more

cucm 11.5 we have the following: phoneA with three lines , line1 and 3 same number and different partitions and both in same pickup group phone B one line and same Pgroup , when I call phoneA line one then im unable to pickup the call using phone B   any idea? does the shared line make the issue?   ... View more

Hi We are upgrading our CUAC advanced from 10.5 to 11.02 , we will upgrade windows then SQl then CUAC (upgrade not fresh installation)   our operators have a private phone book (menu ), how can we keep it in the new version? should we install the new client over the old one without remove it to keep those numbers? ... View more