11-23-2011 04:55 AM - edited 03-16-2019 08:11 AM
Hi everyone. I have issue with one of client request. He needs that when boss press button on the phone the call go automaticly without any number string through fxo port to another phone that directly connect to this fxo port and same with back direction when in opposite side up receiver call automaticly go to this phone through fxo port . how can i implement this funtion in call manager 8.5.
thank everybody before. This is very urgenly if you can please help to solve this issue.
11-23-2011 05:47 AM
CUCM does not have the trunk command/concept as CME does. CUCM is only a PBX, not a key system/hybrid system.
For outbound you will need to configure a partition, CSS and route patterns that only use that FXO port. You can then assign this CSS to that DN. This will force you to not assign a CSS to the device which breaks best practices.
The inbound direction is far easier. Either on the gateway or the analog port in CUCM (depending on protocol used) just set that FXO port to call the extension of the DN configured on that phone.
11-23-2011 12:15 PM
FXO /FXS port ? , If FXO it must be a line coming from PSTN , if FXS ,what gw protocol you are using H323/MGCP?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide