07-05-2018 11:03 PM - edited 03-17-2019 01:09 PM
Hi all,
can you please help me ?
I am deploying Cisco 4321 router using the ports on NIM-2BRI-NT/TE modules.
I have a really poor voice quality on the outgoing or incomming PSTN calls passing throught the BRI port.
I have configured the codec but this did not change.
Do I miss some thing in my configuration ? Please Help Me .
interface GigabitEthernet0/0/0
no ip address
negotiation auto
!
interface GigabitEthernet0/0/0.1
description "Interface VLAN VOICE Agence"
encapsulation dot1Q 330
ip address 10.161.4.33 255.255.255.240
h323-gateway voip interface
h323-gateway voip bind srcaddr 10.161.4.33
!
interface GigabitEthernet0/0/1
description "vers interco"
ip address 192.168.44.158 255.255.255.224
negotiation auto
!
interface Service-Engine0/1/2
!
interface GigabitEthernet0
vrf forwarding Mgmt-intf
no ip address
shutdown
negotiation auto
!
interface BRI0/1/0:0
no ip address
isdn switch-type basic-net3
isdn point-to-point-setup
isdn incoming-voice voice
isdn sending-complete
isdn static-tei 0
trunk-group ALL_BRI
!
interface BRI0/1/1:0
no ip address
isdn switch-type basic-net3
isdn point-to-point-setup
isdn incoming-voice voice
isdn sending-complete
isdn static-tei 0
isdn skipsend-idverify
trunk-group ALL_BRI
voice-port 0/1/0
cptone FR
bearer-cap Speech
!
voice-port 0/1/1
cptone FR
bearer-cap Speech
!
!
!
!
!
port 0/1/0
forward-digits 8
!
dial-peer voice 20 pots
description "INTNATIONAL CALLS IN SRST MODE""
preference 1
destination-pattern .T
progress_ind setup enable 3
progress_ind progress enable 8
progress_ind connect enable 8
incoming called-number .
port 0/1/1
!
dial-peer voice 10 pots
description "INTNATIONAL CALLS IN SRST MODE"
preference 2
destination-pattern .T
progress_ind setup enable 3
progress_ind progress enable 8
progress_ind connect enable 8
incoming called-number .
port 0/1/0
!
dial-peer voice 100 voip
preference 1
destination-pattern 8204..
session target ipv4:10.163.100.7
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
!
dial-peer voice 200 voip
preference 2
destination-pattern 8204..
session target ipv4:10.163.100.8
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
!
!
num-exp 9075 20412
num-exp 9076 20413
num-exp 9077 20414
num-exp 9078 20415
07-05-2018 11:19 PM
where are your phones registered? on the same voice gateway? or on cucm?
07-05-2018 11:22 PM
Hi Denis,
The phones are registered on CUCM.
07-09-2018 12:35 PM
Hi all,
Anybody have a solution that can help me solve this issue ?
I am still looking for a solution.
Zanga
07-09-2018 12:43 PM
Hi all
I am still looking for a solution.
Zanga
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide