10-20-2021 12:19 PM
Good afternoon-
We have just installed a Vg-450. When we create a POTS line and add the config, it will not register until we reset the entire gateway. After that the port registers and functions correctly.
Are we missing something?
Steve McFarland
10-20-2021 06:13 PM
I assume that you register the VG with a CUCM, Can we know the protocol used. And could you share your VG configuration.
10-22-2021 07:48 AM
We are using MGCP.
I am not allowed to send the configuration. I can't continue with this resource.
Thank you for your time.
10-22-2021 11:57 PM
With MGCP I think that you would need to reset the gateway once you complete the configuration of the directory number(s). As you say that it is working after this I’m going to say that this is working as intended.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide