06-15-2012 02:47 AM - edited 03-16-2019 11:40 AM
Hello All,
I have a customer who is about to install siemens phones. I have been asked to configure Qos on the access ports + Uplink ports.
I have applied : "mls qos trust dscp" on access ports but was wondering if i can put "auto qos trust" on access ports as well?
Please see below - This is what i have done so far:
interface gig3/0/34
switchport access vlan 108
switchport mode access
switchport voice vlan 109
mls qos trust dscp
storm-control broadcast level 10.00
spanning-tree portfast
spanning-tree bpduguard enable
I was going to add "auto qos trust" which would result in the following:
interface gig3/0/34
switchport access vlan 108
switchport mode access
switchport voice vlan 109
srr-queue bandwidth share 1 30 35 5
queue-set 2
priority-queue out
mls qos trust dscp
auto qos trust
storm-control broadcast level 10.00
spanning-tree portfast
spanning-tree bpduguard enable
As these are no Cisco phones im not sure which to use.
Many thanks in advance.
Martin.
Solved! Go to Solution.
06-15-2012 09:29 AM
Dont need the mls qos trsut dscp, should just be able to get away with the auto qos command.
06-15-2012 09:29 AM
Dont need the mls qos trsut dscp, should just be able to get away with the auto qos command.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: